Sandia, U.S. Air Force test airborne Harvester sensor payload

ALBUQUERQUE, N.M., 10 Jan. 2013. U.S. Air Force personnel, together with industry and academia, are testing the capabilities of relatively inexpensive unmanned aerial vehicles (UAVs) equipped with radiation sensors from Sandia National Laboratories engineers.

Harvester, a Sandia National Laboratories-developed airborne particulate-collection system, is designed to collect airborne radioactive particles for analysis from its perch on a remotely piloted aircraft system (RPAS). Harvester would be called upon in the event of nuclear device detonation virtually anywhere on Earth.

A team of engineers demonstrated Harvester’s capabilities at Grand Forks Air Force Base in Grand Forks, N.D., in late September. The system “tasted” the atmosphere with two particulate sampling pods during the event, according to a spokesperson. A third pod would provide directional guidance by following the trail of gamma radiation during an actual event.

The system could “fly right down the throat of telltale radiation over a broad range of altitudes [to collect much-needed radiation data] without exposing a human crew to hazards,” the spokesperson adds.

The Grand Forks demonstration is part of a formal Department of Defense (DOD) Joint Capability Technology Demonstration (JCTD) that mated the Harvester modular pods to the long wings of a Department of Homeland Security Customs and Border Protection-provided MQ-9 Reaper UAV.

The modular pods eliminate the need for costly, permanent aircraft modifications that would limit the number of aircraft platforms on which Harvester can be flown.

Officials anticipate the three sensor pods plus additional hardware, software, and ground-control equipment to be deployed on aircraft in the Air Force’s investigatory arsenal in the next few years.

 Photo by Randy Montoya.

“There’s a high likelihood the Air Force will make Harvester operational in 2014 to augment its current manned aircraft collection capability,” says Sandia Project Lead Joe Sanders. “For maximum responsiveness, we continually engaged with the Air Force to address its technological and operational needs throughout the project.”

The Harvester’s Directional Gamma Radiation Sensor (DGRS) helps guide the aircraft toward the radioactive plume using four large sodium-iodide radiation detectors and a complex processing algorithm. The Harvester equipment operator informs the pilot, in a remote UAV ground control station, to fly toward the plume’s “hot spot.”

Air passes through the samplers as the Reaper cruises at 200 mph, as particles stick to filter paper fibers. A separate radiation sensor analyzes the filter in real time to estimate the type and quantity of radioactive particles collected. More extensive examination of the filters occurs after the aircraft has landed.

Photo by Joe Sanders.

Harvester was developed by Sandia with support from the Albuquerque office of National Technical Systems, an international engineering firm. The National Nuclear Security Administration’s Office of Nonproliferation Research and Development funded the research and development phase, while the Defense Threat Reduction Agency and the Office of the Secretary of Defense’s Acquisition, Technology, and Logistics Rapid Fielding Office funded the development and qualification phase as part of the JCTD.

Related Products

VPX3-453 3U VPX Virtex-6/8640D Digital Signal Processor

The Curtiss-Wright VPX3-453 is a high performance 3U VPX DSP and FPGA processor card th...

CHAMP-FX4 6U OpenVPX Virtex-7 FPGA Processor Card

The CHAMP-FX4 is the flagship 6U product in Curtiss-Wright Defense Solutions’ family of...

PMC-E2001 Audio/Acoustic Waveform Generating PMC Card

PMC-E2001 Delta-sigma PMC features 16-bit resolution with 8 Analog Outputs and 4 Analog...

Related Companies

Curtiss-Wright Defense Solutions

About Curtiss-Wright Defense Solutions Curtiss-Wright Defense Solutions (CWDS) is a lon...

Innovative Integration

  Since 1988, Innovative Integration has grown to become one of the world's leading supplier...

General Micro Systems Inc

Since 1979, General Micro Systems has been providing the most diverse line of single-board comput...
Wire News provided by   

 

Press Releases

Low Viscosity, One Part Cyanoacrylate Is Non-Toxic and Meets ISO 10993-5 Specifications

Master Bond MB250NT is widely used for a variety of applications ranging from repair to high speed pro...

Thermally Conductive, Two Component Epoxy Passes USP Class VI Tests and ISO 10993-5 Specifications

With biocompatibility and cytotoxicity certifications, Master Bond EP21AOLV-2Med is often selected for...

One Component, Snap Cure Epoxy Features High Strength Properties

Suitable for a variety of applications in the electronic, aerospace and OEM industries, Master Bond EP...

One Part Epoxy Resists up to 500°F and Meets NASA Low Outgassing Specifications

Master Bond Supreme 12AOHT-LO is a one component epoxy for a variety of bonding and sealing applicatio...

CURTISS-WRIGHT CONGRATULATES NORTHROP GRUMMAN ON SUCCESSFUL FIRST FLIGHT OF SECOND MQ-4C TRITON UAS

Curtiss-Wright Corporation’s Defense Solutions division applauds Northrop Grumman Corporation (NYSE: N...

Curtiss-Wright’s New Rugged Mobile IP Router Subsystem Features an Integrated Cisco® 5915 ESR Router

Curtiss-Wright Corporation today announced that its Defense Solutions division, a Cisco® Systems Solut...

VICTORY Shared Processing, Fire Control Computer, and Switch for Ground Vehicles Introduced by Curtiss-Wright

Curtiss-Wright Corporation today announced that its Defense Solutions division has introduced a new fu...

GE Announces First Sub-Credit Card-Sized Multi-Function High Definition (HD) Video Tracker

HUNTSVILLE, AL.— OCTOBER 13, 2014—GE’s Intelligent Platforms business today announced at AUSA (Octobe...

Most Popular Articles


All Access Sponsors


Follow Us On...